The Ecovector High level fan assisted heaters (hydronic) provide effective and dependable heating for both small and large commercial areas, fitted unobtrusively above head height
- They work particularly well in shops and libraries, where lower wall space is limited
- Compatible with most types of wet central heating systems, functioning equally efficiently with conventional boilers, biomass technology or ground or air source heat pumps
- Ecovector® Low fan convectors provide warmth from the floor upwards and are more energy efficient and effective than radiators
- Ecovector® Vertical is ideal for those hard to heat places, such as reception areas and alcoves
Motor
AC only
Finish
Front casing: zinc-coated steel.
Polyester powder-coated RAL 9010
Side panels: polymer eggshell white
Installation
Maximum installation height 2.1m to underside
No top or side clearance required
Unit must be earthed (except model 1000-12V)
Suitable for two-pipe central heating systems
Patress box not supplied for transformer (model 1000-12V)
Commissioning
Check water is hot enough to activate the low temperature cut-outthermostat. The inclusion of an automatic air vent at the highest point is recommended to avoid possible air locks
Controls
Two rocker switches – normal/off/boost, heating/fan-only
Low temperature cut out thermostat, set to energise fan at approximately 35°C
For technical data and ordering guides click here
The Smith’s technical sales team is available to offer free, no-obligation advice on the best heating solution for an almost exhaustive range of applications. Contact us